1. 取扱説明書・マニュアル >
2. DELL >
3. パソコン >
4. パソコン本体 >
5. デスクトップパソコン >
6. OptiPlex G1 の使い方、故障・トラブル対処法 >
7. OptiPlex G1 の取扱説明書・マニュアル

OptiPlex G1の取扱説明書・マニュアル [全174ページ 1.59MB]

System Setup Options: Dell OptiPlex GX1 Small-Form-Factor System User's Guidefile:///C|/infodev/2013/eDoc/OpGX1/UG/setupopt.htm [2/21/2013 11:47:16 AM]1. Remove the computer cover . NOTICE: Verify that the AC power cable is removed before changing any jumper settings.2. Remove the jumper plug from the PSWD jumper to disable the password feature.See Figure 4 in "Inside Your Computer" for the location of the password jumper (labeled "PSWD")on the system board.3. Replace the computer cover.4. Reconnect your computer and peripherals to their electrical outlets, and then turn them on.Booting your system with the PSWD jumper plug removed erases the existing password(s).5. Enter the System Setup program and verify that the password is disabled. Proceed to step 6 if youwant to assign a new password.NOTE: Before you assign a new system and/or setup password, you must replace thePSWD jumper plug.6. Remove the computer cover . 7. Replace the PSWD jumper plug.8. Replace the computer cover, and then reconnect the computer and peripherals to their electricaloutlets and turn them on.Booting with the PSWD jumper installed reenables the password feature. When you enter theSystem Setup program, both password options appear as Not Enabled, meaning that thepassword feature is enabled but that no password has been assigned.9. Assign a new system password and/or setup password.Responding to Error MessagesIf an error message appears on your monitor screen while the system is booting, make note of the message.Then, before entering the System Setup program, refer to "Messages and Codes" for an explanation of themessage and suggestions for correcting any errors. However, it is normal to receive an error message thefirst time you boot the system after a memory upgrade. In that case, refer to the instructions in "SystemMemory."If you are given an option to press either <F1> to continue or <F2> to run the System Setup program, pressthe <F2> key.Back to Contents Page

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.