OptiPlex G1の取扱説明書・マニュアル [全174ページ 1.59MB]
optiplex-g1_User%27s%20Guide_en-us.pdf
ftp://ftp.dell.com/.../optiplex-g1_User%27s%20Guide_en-us.pdf - 1.59MB
- キャッシュ
22255view
174page / 1.59MB
Inside Your Computer: Dell OptiPlex GX1 Small-Form-Factor System User's Guidefile:///C|/infodev/2013/eDoc/OpGX1/UG/inside.htm [2/21/2013 11:47:19 AM]Password features are disabled.BIOS (default)Reserved (do not change)BUS66M (default)Reserved (do not change)266MHZ* (default)Reserved (do not change)300MHZ* (default)Reserved (do not change)333MHZ* (default)Reserved (do not change)350MHZ* (default)Reserved (do not change)400MHZ* (default)Reserved (do not change)450MHZ* (default)Reserved (do not change)500MHZ* (default)Reserved (do not change)*The correct microprocessor speed is automatically detected and set by the system. Do not change thesettings of these jumpers.The system can operate with a microprocessor speed up to 600 MHz.NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in your online SystemUser's Guide.jumpered unjumperedSystem Board LabelsTable 2 lists the labels for light-emitting diode (LED) indicators, connectors, and sockets on the systemboard, and it gives a brief description of their functions.Table 2. System Board Indicators, Connectors, and SocketsConnector orSocketDescriptionAMCATI multimedia channelBATTERYBattery socketCD_INCD-ROM audio interface connectorDIMM_xDIMM socketDSKTDiskette/tape drive interface connectorENETNIC connector (optional)FANMicroprocessor fan connectorHDLEDHard-disk drive LED connector (on riser board)IDEnEIDE interface connectorINTRUSIONChassis intrusion switch connector
参考になったと評価
2人が参考になったと評価しています。
その他の取扱説明書
237 view
184 view
252 view