OptiPlex G1の取扱説明書・マニュアル [全174ページ 1.59MB]
optiplex-g1_User%27s%20Guide_en-us.pdf
ftp://ftp.dell.com/.../optiplex-g1_User%27s%20Guide_en-us.pdf - 1.59MB
- キャッシュ
22255view
174page / 1.59MB
Hard-Disk Drives: Dell OptiPlex GX1 Small-Form-Factor System User's Guidefile:///C|/infodev/2013/eDoc/OpGX1/UG/harddisk.htm [2/21/2013 11:47:23 AM]12. Start the computer system.NOTE: If the drive you just installed is the primary drive and no operating system is installed, youmust start the computer using a bootable diskette or CD.To boot the system from a diskette, insert a bootable diskette (such as an operating systeminstallation or recovery diskette) into diskette drive A, and turn on the computer.To boot the system from a CD, enter the System Setup program and set the Boot Sequence toCD-ROM First. Insert a bootable CD (such as an operating system installation CD or the DellResourceCD) into CD-ROM drive, and turn on the computer.NOTE: If Enabled, the Chassis Intrusion option will cause the following message to be displayedat the next system start-up:ALERT! Cover was previously removed.13. Enter the System Setup program and update the Drives: Primary and Secondary options.After you update the System Setup options, reboot the system.14. Partition and logically format the drive before proceeding to the next step.15. Run the Hard-Disk Drive(s) Test Group in the Dell Diagnostics to verify that the new hard-disk drive isoperating properly.16. If the drive you just installed is the primary drive, install the operating system on the hard-disk drive.Refer to the documentation that came with the operating system.Back to Contents Page
参考になったと評価
2人が参考になったと評価しています。
その他の取扱説明書
237 view
184 view
252 view