Z4の取扱説明書・マニュアル [全247ページ 11.67MB]
123894.pdf
gizport - 2013-09-07
http://153.127.246.254/.../123894.pdf - 11.67MB
- キャッシュ
38351view
247page / 11.67MB
Replacing componentsTool kitThe onboard vehicle tool kit is stored in a pouchunder the trunk floor panel.Replacing the wiper blades1. Fold up the wiper arm.2.Fold the wiper blade upwards.3.Press the hook.4.Pull the wiper blade downward out of theholder and remove it toward the top left, seearrow.Do not fold out the wiper armsTo avoid damage, make sure that thewiper arms are resting against the windshieldbefore you open the engine compartment.◀Lamp and bulb replacementGeneral informationLamps and bulbs make an essential contributionto vehicle safety.The manufacturer of your vehicle recommendsthat you entrust corresponding procedures toyour service center if you are unfamiliar withthem or they are not described here.You can obtain a selection of replacement bulbsat your service center.Danger of burnsOnly change bulbs when they are cool;otherwise, there is the danger of gettingburned.◀Working on the lighting systemWhen working on the lighting system, youshould always switch off the lights affected toprevent short circuits.To avoid possible injury or equipment damagewhen replacing bulbs, observe any instructionsprovided by the bulb manufacturer.◀Do not touch the bulbsDo not touch the glass of new bulbs withyour bare hands, as even minute amounts ofcontamination will burn into the bulb's surfaceand reduce its service life.Use a clean tissue, cloth or something similar, orhold the bulb by its base.◀Light-emitting diodes LEDLight-emitting diodes installed behind translu‐cent lenses serve as the light source for many ofthe controls and displays in your vehicle.These light-emitting diodes, which operate us‐ing a concept similar to that applied in conven‐tional lasers, are officially designated as Class 1light-emitting diodes.Do not remove the coversDo not remove the covers, and never stareinto the unfiltered light for several hours; other‐wise, irritation of the retina could result.◀Headlamp glassCondensation can form on the inside of the ex‐ternal lamps in cool or humid weather. When theSeite 204204Online Edition for Part no. 01 41 2 604 231 - 03 10 500Replacing components
参考になったと評価
11人が参考になったと評価しています。
その他の取扱説明書
31138 view
13905 view
21365 view
21069 view
21361 view
もっと見る