Z4の取扱説明書・マニュアル [全247ページ 11.67MB]
123894.pdf
gizport - 2013-09-07
http://153.127.246.254/.../123894.pdf - 11.67MB
- キャッシュ
38351view
247page / 11.67MB
Operational readiness of airbag systemIn the radio ready state and beyond, refer topage 50 , the warning lamp comes on briefly toindicate that the entire airbag system and thebelt tensioners are operational.Airbag system malfunction▷Warning lamp does not light up in the radioready state.▷Warning lamp remains permanently on.Have the airbag system checked withoutdelay if there is a malfunctionIn the event of a malfunction in the airbag sys‐tem, have it checked without delay; otherwise,there is the risk that the system will not functionas intended even if a sufficiently severe accidentoccurs.◀Flat Tire Monitor FTM*The conceptThe system detects a pressure loss in a tire onthe basis of speed differences between the in‐dividual wheels during a trip.In the event of pressure loss, the rolling circum‐ference changes and, thus, the rotating speedof the affected wheel. This change is detectedand is reported as a flat tire.Functional requirementsThe system must have been initialized when thetire inflation pressure was correct; otherwise,reliable signaling of a flat tire is not ensured. In‐itialize the system after each correction of thetire inflation pressure and after every tire orwheel change.System limitsSudden tire damageSudden serious tire damage caused byexternal influences cannot be indicated in ad‐vance.◀A natural, even pressure loss in all four tires can‐not be detected.The system could be delayed or malfunction inthe following situations:▷When the system has not been initialized.▷When driving on a snowy or slippery roadsurface.▷Sporty driving style: slip in the drive wheels,high lateral acceleration.▷When driving with snow chains.InitializationThe initialization process adopts the set inflationtire pressures as reference values for the detec‐tion of a flat tire. Initialization is started by con‐firming the inflation pressures.Do not initialize the system when driving withsnow chains*.1. "Vehicle Info"2. "Vehicle status"3."Reset"4.Start the engine - do not drive away.5. Start the initialization with "Reset".6. Drive away.The initialization is completed while driving,which can be interrupted at any time.The initialization automatically continues whendriving resumes.Seite 8282Online Edition for Part no. 01 41 2 604 231 - 03 10 500Safety
参考になったと評価
11人が参考になったと評価しています。
その他の取扱説明書
31138 view
13905 view
21365 view
21069 view
21361 view
もっと見る