Z4の取扱説明書・マニュアル [全247ページ 11.67MB]
123894.pdf
gizport - 2013-09-07
http://153.127.246.254/.../123894.pdf - 11.67MB
- キャッシュ
38351view
247page / 11.67MB
Switching offPress the button longer.The LEDs go out.Safety beltsGeneral informationAlways make sure that safety belts are beingworn by all occupants before driving away.Although airbags enhance safety by providingadded protection, they are not a substitute forsafety belts.Seats with safety beltThe vehicle has two seats, each of which isequipped with a safety belt.The shoulder strap's anchorage point will becorrect for adult seat occupants of every build ifthe seat is correctly adjusted.One person per safety beltNever allow more than one person to weara single safety belt. Never allow infants or smallchildren to ride on a passenger's lap.◀Putting on the beltLay the belt, without twisting, snuglyacross the lap and shoulders, as close to thebody as possible. Make sure that the belt lies lowaround the hips in the lap area and does notpress on the abdomen. Otherwise, the belt canslip over the hips in the lap area in a frontal im‐pact and injure the abdomen.The safety belt must not lie across the neck, rubon sharp edges, be routed over solid or breaka‐ble objects, or be pinched.◀Reduction of restraining effectAvoid wearing clothing that prevents thebelt from fitting properly, and pull the shoulderbelt periodically to readjust the tension acrossyour lap; otherwise, the retention effect of thesafety belt may be reduced.◀Buckling the beltMake sure you hear the latch plate engage in thebelt buckle.Unbuckling the belt1. Hold the belt firmly.2. Press the red button in the belt buckle.3. Guide the belt back into its reel.Safety belt reminder for driver andpassenger*The indicator lamp lights up and a sig‐nal sounds. In addition, a message ap‐pears on the Control Display. Checkwhether the safety belt has been fas‐tened correctly.The safety belt reminder is active at speedsabove approx. 5 mph/8 km/h. It can also be ac‐tivated if objects are placed on the front pas‐senger seat.Damage to safety beltsIn the case of strain caused by accidents ordamage:Have the safety belts, including the safety belttensioners, replaced and have the belt anchorschecked.Checking and replacing safety beltsHave the work performed only by yourservice center; otherwise, it cannot be ensuredthat this safety feature will function properly.◀Seite 4444Online Edition for Part no. 01 41 2 604 231 - 03 10 500Adjusting
参考になったと評価
11人が参考になったと評価しています。
その他の取扱説明書
31138 view
13905 view
21365 view
21069 view
21361 view
もっと見る