クライスラー・300Cの取扱説明書・マニュアル [全592ページ 4.48MB]
94996.pdf
http://153.127.244.43/.../94996.pdf - 4.48MB
- キャッシュ
90440view
592page / 4.48MB
Indicator Light (MIL) is functioning and is not on whenthe engine is running, and that the OBD II system isready for testing.Normally, the OBD II system will be ready. The OBD IIsystem maynotbe ready if your vehicle was recentlyserviced, recently had a dead battery or a battery replace-ment. If the OBD II system should be determined notready for the I/M test, your vehicle may fail the test.Your vehicle has a simple ignition key-actuated test,which you can use prior to going to the test station. Tocheck if your vehicles OBD II system is ready, you mustdo the following:1. Cycle the ignition switch to the ON position, but donot crank or start the engine.2. If you crank or start the engine, you will have to startthis test over.3. As soon as you cycle the ignition switch to the ONposition, you will see the MIL symbol come on as partof a normal bulb check.4. Approximately 15 seconds later, one of two things willhappen:•The MIL will flash for about 10 seconds and thenreturn to being fully illuminated until you turn OFFthe ignition or start the engine. This means that yourvehicles OBD II system is not readyand you shouldnotproceed to the I/M station.•The MIL will not flash at all and will remain fullyilluminated until you turn OFF the ignition or start theengine. This means that your vehicles OBD II systemisreadyand you can proceed to the I/M station.If your OBD II system is not ready,you should see yourauthorized dealer or repair facility. If your vehicle wasrecently serviced or had a battery failure or replacement,498 MAINTAINING YOUR VEHICLE
参考になったと評価
30人が参考になったと評価しています。
その他の取扱説明書
2809 view
726 view
1920 view
912 view
339 view
もっと見る