クライスラー・300Cの取扱説明書・マニュアル [全592ページ 4.48MB]
94996.pdf
http://153.127.244.43/.../94996.pdf - 4.48MB
- キャッシュ
90178view
592page / 4.48MB
5. If the child restraint has a top tether strap and theseating position has a top tether anchorage, connectthe tether strap to the anchorage and tighten the tetherstrap. Refer to Lower Anchors and Tethers for Chil-dren (LATCH) Restraint System for directions toattach a tether anchor.6. Test that the child restraint is installed tightly bypulling back and forth on the child seat at the beltpath. It should not move more than 1 inch (25.4 mm)in any direction.Any seat belt system will loosen with time, so check thebelt occasionally, and pull it tight if necessary.If the buckle or the cinching latch plate is too close to thebelt path opening of the child restraint, you may havetrouble tightening the seat belt. If this happens, discon-nect the latch plate from the buckle and twist the shortbuckle-end belt up to three full turns to shorten it. Insertthe latch plate into the buckle with the release buttonfacing out, away from the child restraint. Repeat steps 4to 6, above, to complete the installation of the childrestraint.If the belt still cannot be tightened after you shorten thebuckle, disconnect the latch plate from the buckle, turnthe buckle around one half turn, and insert the latch plateinto the buckle again. If you still cannot make the childrestraint installation tight, try a different seating position.2THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 91
参考になったと評価
30人が参考になったと評価しています。
その他の取扱説明書
2808 view
726 view
1918 view
909 view
339 view
もっと見る