クライスラー・300Cの取扱説明書・マニュアル [全592ページ 4.48MB]
94996.pdf
http://153.127.244.43/.../94996.pdf - 4.48MB
- キャッシュ
90652view
592page / 4.48MB
To program the remaining two HomeLinkfi buttons,repeat each step for each remaining button. DO NOTerase the channels.Reprogramming A Single HomeLink(R) ButtonTo reprogram a channel that has been previously trained,follow these steps:1. Cycle the ignition to the ON/RUN position.2. Press and hold the desired HomeLinkfi button untilthe indicator light begins to flash after 20 seconds. Donot release the button.3.Without releasing the button proceed with Program-ming ARolling Code Step 2 and follow all remainingsteps.Programming A Non-Rolling CodeFor programming Garage Door Openers manufacturedbefore 1995.1. Turn the ignition switch to the ON/RUN position.2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm)away from the HomeLinkfi button you wish to pro-gram while keeping the HomeLinkfi indicator light inview.3. Simultaneously press and hold both the Homelinkfibutton you want to program and the hand-held trans-mitter button.4. Continue to hold both buttons and observe the indi-cator light. The Homelinkfi indicator will flash slowlyand then rapidly after HomeLinkfi has received thefrequency signal from the hand-held transmitter. Re-lease both buttons after the indicator light changesfrom slow to rapid.5. Press and hold the programmed HomeLinkfi buttonand observe the indicator light.266 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
参考になったと評価
30人が参考になったと評価しています。
その他の取扱説明書
2809 view
727 view
1920 view
912 view
339 view
もっと見る