クライスラー・300Cの取扱説明書・マニュアル [全592ページ 4.48MB]
94996.pdf
http://153.127.244.43/.../94996.pdf - 4.48MB
- キャッシュ
90652view
592page / 4.48MB
4. If you wish to stop the cranking of the engine prior tothe engine starting, press the button again.NOTE:Normal starting of either a cold or a warmengine is obtained without pumping or pressing theaccelerator pedal.To Turn Off The Engine Using ENGINESTART/STOP Button1. Place the shift lever in PARK, then press and releasethe ENGINE START/STOP button.2. The ignition switch will return to the OFF position.3. If the shift lever is not in PARK, the ENGINE START/STOPbutton must be held for two seconds and vehiclespeed must be above 5 mph (8 km/h) before theengine will shut off. The ignition switch position willremain in the ACC position until the shift lever is inPARK and the button is pressed twice to the OFFposition. If the shift lever is not in PARK and theENGINE START/STOP button is pressed once, theEVIC (if equipped) will display a Vehicle Not InPark message and the engine will remain running.Never leave a vehicle out of the PARK position, or itcould roll.NOTE:If the ignition switch is left in the ACC or RUN(engine not running) position and the transmission is inPARK, the system will automatically time out after 30minutes of inactivity and the ignition will switch to theOFF position.ENGINE START/STOP Button Functions - WithDriver's Foot OFF The Brake Pedal (In PARK OrNEUTRAL Position)The ENGINE START/STOP button operates similar to anignition switch. It has four positions, OFF, ACC, RUNand START. To change the ignition switch positionswithout starting the vehicle and use the accessoriesfollow these steps.366 STARTING AND OPERATING
参考になったと評価
30人が参考になったと評価しています。
その他の取扱説明書
2809 view
727 view
1920 view
912 view
339 view
もっと見る