クライスラー・300Cの取扱説明書・マニュアル [全592ページ 4.48MB]
94996.pdf
http://153.127.244.43/.../94996.pdf - 4.48MB
- キャッシュ
90652view
592page / 4.48MB
conditions require increased levels of road traction, thevehicle automatically shifts into AWD mode. AutomaticAWD operation could be activated by outside tempera-ture, wheel slip, or other predetermined conditions (theremay be a slight delay forAWD engagement after a wheelslip condition occurs). AWD can also be manually se-lected by moving the shift lever into the AutoStickfimode (+/-) or activating the windshield wipers for anextended period of time. Drive mode, RWD or AWD, isdisplayed momentarily in the Electronic Vehicle Informa-tion Center (EVIC) in the gauge area of the vehicledisplay when the transmission is first shifted into gear,and if the drive mode changes during vehicle operation.NOTE:If the SERVICE AWD SYSTEM warning mes-sage appears after engine start up, or during driving, itmeans that the AWD system is not functioning properlyand that service is required. Refer to Electronic VehicleInformation Center (EVIC) in Understanding YourInstrument Panel for further information.CAUTION!All wheels must have the same size and type tires.Unequal tire sizes must not be used. Unequal tiresize may cause failure of the front differential and/orthe transfer case.DRIVING ON SLIPPERY SURFACESAccelerationRapid acceleration on snow covered, wet, or other slip-pery surfaces may cause the driving wheels to pullerratically to the right or left. This phenomenon occurswhen there is a difference in the surface traction underthe rear (driving) wheels.5STARTING AND OPERATING 391
参考になったと評価
30人が参考になったと評価しています。
その他の取扱説明書
2809 view
727 view
1920 view
912 view
339 view
もっと見る