Z4の取扱説明書・マニュアル [全220ページ 9.90MB]
123916.pdf
gizport - 2013-09-07
http://153.127.246.254/.../123916.pdf - 9.90MB
- キャッシュ
31138view
220page / 9.90MB
Preparation1. Check that the battery of the other vehiclehas a voltage of 12 V. This information canbe found on the battery.2. Switch off the engine of the assisting vehi‐cle.3. Switch off any electronic systems/powerconsumers in both vehicles.Bodywork contact between vehiclesMake sure that there is no contact be‐tween the bodywork of the two vehicles;otherwise, there is the danger of short cir‐cuits.◀Starting aid terminalsConnecting orderConnect the jumper cables in the correctorder; otherwise, there is the danger of injuryfrom sparking.◀The so-called starting aid terminal in the enginecompartment acts as the battery's positive ter‐minal.The body ground or a special nut acts as thenegative terminal.Connecting jumper cables1. Pull off the cap of the BMW starting aid ter‐minal.2. Attach one terminal clamp of the positivejumper cable to the positive terminal of thebattery, or to the corresponding starting aidterminal of the vehicle providing assistance.3. Attach the other end of the cable to the pos‐itive terminal of the battery, or to the corre‐sponding starting aid terminal of the vehicleto be started.4. Attach one terminal clamp of the negativejumper cable to the negative terminal of thebattery, or to the corresponding engine orbody ground of the vehicle providing assis‐tance.5. Attach the other end of the cable to the neg‐ative terminal of the battery, or to the corre‐sponding engine or body ground of the ve‐hicle to be started.Starting the engineNever use spray fluids to start the engine.1. Start the engine of the assisting vehicle andlet it run for several minutes at an increasedidle speed.If the vehicle being started has a diesel en‐gine: let the engine of the assisting vehiclerun for approx. 10 minutes.2.Start the engine of the vehicle being startedin the usual way.If the first starting attempt is not successful,wait a few minutes before making anotherattempt in order to allow the discharged bat‐tery to recharge.3.Let both engines run for several minutes.4. Disconnect the jumper cables in the reverseorder.Check the battery and recharge if necessary.Seite 178Mobility Breakdown assistance178Online Edition for Part no. 01 40 2 609 184 - 09 11 500
参考になったと評価
11人が参考になったと評価しています。
その他の取扱説明書
38351 view
13905 view
21365 view
21069 view
21361 view
もっと見る