1. 取扱説明書・マニュアル >
2. BMW >
3. 自動車 >
4. Z4 の使い方、故障・トラブル対処法 >
5. Z4 の取扱説明書・マニュアル

Z4の取扱説明書・マニュアル [全220ページ 9.90MB]

distance depends on the particular hand-held transmitter.4. Press the button of the desired function onthe hand-held transmitter and the buttonbeing programmed on the interior rearviewmirror simultaneously and hold. The LED onthe interior rearview mirror flashes slowly atfirst.5. When the LED flashes more rapidly, releaseboth buttons. Rapid flashing indicates thatthe button on the interior rearview mirror hasbeen programmed.If the LED does not flash faster after 60 sec‐onds, change the distance between the in‐terior rearview mirror and the hand-heldtransmitter and repeat the step. Multiple tri‐als at different distances may be necessary.Wait at least 15 seconds between trials.Canada: If the programming procedure withthe hand-held transmitter was interrupted,press and hold the button on the interiorrearview mirror and press the button on thehand-held transmitter multiple times for2 seconds each and release.6. To program additional functions on otherbuttons, repeat steps 3 to 5.The systems can be operated with the buttonson the interior rearview mirror.Special characteristics of alternating-code radio systemsIf the system cannot be operated after repeatedprogramming, check whether the system to beoperated uses an alternating-code system.Read the operating instructions of the system orpress and hold the programmed button on theinterior rearview mirror. If the LED on the interiorrearview mirror flashes rapidly at first and thenlights up continuously for 2 seconds, the systemis equipped with an alternating-code system.This flashing LED pattern repeats itself for ap‐prox. 20 seconds.In systems with an alternating-code system, theUniversal Garage Door Opener and the systemmust be additionally synchronized.Please obtain additional information on syn‐chronization in the operating instructions of thesystem being set up.The systems will be easier to synchronize withthe aid of a second person.Synchronization:1. Park the vehicle within range of the remote-controlled system.2. Program the corresponding button on theinterior rearview mirror as described.3. Identify and press the synchronization but‐ton on the system being set up. You haveapprox. 30 seconds for the next step.4. Press and hold the button on the interiorrearview mirror for approx. 3 seconds andthen release it. Repeat this step up to threetimes if necessary to complete the synchro‐nization procedure. When synchronizationis completed, the programmed function isexecuted.Reprogramming individual buttons1. Switch on the ignition.2.Hold the hand-held transmitter at a distanceof approx. 1 to 3 in/2.5 to 8 cm from thememory buttons.The required distance depends on the par‐ticular hand-held transmitter.3.Press the memory button of the UniversalGarage Door Opener.4.If the LED flashes slowly after approx.20 seconds, press the transmit button onthe hand-held transmitter.5. Release both buttons when the LED flashesrapidly.If the LED does not flash rapidly after approx.60 seconds, change the distance and repeatthe step.Seite 97Interior equipment Controls97Online Edition for Part no. 01 40 2 609 184 - 09 11 500

もっと見る

このマニュアルの目次

Copyright © 2013 Gizport.jp All Rights Reserved.