クライスラー・300Cの取扱説明書・マニュアル [全592ページ 4.48MB]
94996.pdf
http://153.127.244.43/.../94996.pdf - 4.48MB
- キャッシュ
93230view
592page / 4.48MB
3. Continue to press and hold the HomeLinkfi button,while you press and release (cycle), your hand-heldtransmitter every two seconds until HomeLinkfi hassuccessfully accepted the frequency signal. The indi-cator light will flash slowly and then rapidly whenfully trained.4. Watch for the HomeLinkfi indicator to change flashrates. When it changes, it is programmed. It may takeup to 30 seconds or longer in rare cases. The garagedoor may open and close while you are programming.5. Press and hold the programmed HomeLinkfi buttonand observe the indicator light.•If the indicator light stays on constantly, program-ming is complete and the garage door/device shouldactivate when the HomeLinkfi button is pressed.•To program the two remaining HomeLinkfi buttons,repeat each step for each remaining button. DO NOTerase the channels.If you unplugged the garage door opener/device forprogramming, plug it back in at this time.Reprogramming A Single HomeLink(R) ButtonTo reprogram a channel that has been previously trained,follow these steps:1. Cycle the ignition to the ON/RUN position.2. Press and hold the desired HomeLinkfi button untilthe indicator light begins to flash after 20 seconds. Donot release the button.268 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
参考になったと評価
30人が参考になったと評価しています。
その他の取扱説明書
2824 view
739 view
1939 view
922 view
349 view
もっと見る