MINIの取扱説明書・マニュアル [全292ページ 7.05MB]
ownersmanual2013couperoadsterconvertible.pdf
gizport - 2013-09-06
http://libraryofmotoring.info/.../ownersmanual2013couperoadsterconvertible.pdf - 7.05MB
- キャッシュ
62224view
292page / 7.05MB
Use a clean tissue, cloth or something similar,or hold the bulb by its base. ◀Caring for the headlamps, refer to page 260 .For bulb replacement that is not describedhere, please contact the service center or aworkshop that works according to the repairprocedures of the manufacturer with corre‐spondingly trained personnel.For checking and adjusting headlamp aim,please contact your MINI dealer.Light-emitting diodes LEDsLight-emitting diodes installed behind translu‐cent lenses serve as the light source for manyof the controls and displays in the vehicle.These light-emitting diodes, which operate us‐ing a concept similar to that applied in conven‐tional lasers, are officially designated as Class 1light-emitting diodes.Do not remove the coversDo not remove the covers, and neverstare into the unfiltered light for several hours;otherwise, irritation of the retina could result. ◀Headlamp glassCondensation can form on the inside of theheadlamps in cool or humid weather. When thelight is switched on, the condensation evapo‐rates after a short time. The headlamps do notneed to be changed.If the condensation in the headlamps does notevaporate after trips with the lights switchedon, and the amount of moisture in the head‐lamps increases, for example if water dropletsform, have them checked by your service cen‐ter.Bi-xenon headlampsThese bulbs have a very long life and the likeli‐hood of failure is very low, provided that theyare not switched on and off excessively. If abulb should nevertheless fail, you can continuedriving cautiously with the front fog lamps, pro‐vided this is permitted by local laws.Do not perform work/bulb replacementon xenon headlampsHave any work on the xenon lighting system,including bulb replacement, performed only bya service center.Due to the high voltage present in the system,there is the danger of fatal injuries if work iscarried out improperly. ◀Front lamps, bulb replacementHalogen low beams and high beamsBulb H13, 60/55 wattWear protective goggles and glovesHalogen bulbs are pressurized. Therefore,wear protective goggles and gloves. Otherwise,there is a danger of injuries if the bulb is acci‐dentally damaged during replacement. ◀Attach the cover carefullyWhen attaching the cover, proceed care‐fully; otherwise, leaks may occur, causing dam‐age to the headlamp system. ◀Access to the bulbs through the enginecompartmentFollow the general instructions on lamps andbulbs, refer to page 244 .Low beam/high beam bulbs can be changedfrom the engine compartment.Seite 245Replacing componentsMobility245Online Edition for Part no. 01 40 2 919 017 - II/13
参考になったと評価
8人が参考になったと評価しています。
その他の取扱説明書
33068 view
11935 view
43011 view
3545 view
28682 view
もっと見る