クライスラー・300Cの取扱説明書・マニュアル [全592ページ 4.48MB]
94996.pdf
http://153.127.244.43/.../94996.pdf - 4.48MB
- キャッシュ
90640view
592page / 4.48MB
•If the indicator light stays on constantly, program-ming is complete and the garage door/device shouldactivate when the HomeLinkfi button is pressed.•To program the two remaining HomeLinkfi buttons,repeat each step for each remaining button. DO NOTerase the channels.Reprogramming A Single HomeLink(R) ButtonTo reprogram a channel that has been previously trained,follow these steps:1. Cycle the ignition to the ON/RUN position.2. Press and hold the desired HomeLinkfi button untilthe indicator light begins to flash after 20 seconds. Donot release the button.3.Without releasing the button proceed with Program-ming A Non-Rolling Code Step 2 and follow allremaining steps.Canadian/Gate Operator ProgrammingFor programming transmitters in Canada/United Statesthat require the transmitter signals to time-out afterseveral seconds of transmission.Canadian radio frequency laws require transmitter sig-nals to time-out (or quit) after several seconds of trans-mission which may not be long enough for HomeLinkfito pick up the signal during programming. Similar to thisCanadian law, some U.S. gate operators are designed totime-out in the same manner.It may be helpful to unplug the device during the cyclingprocess to prevent possible overheating of the garagedoor or gate motor.1. Cycle the ignition to the ON/RUN position.2.Place the hand-held transmitter 1 to 3 in (3 to 8 cm) awayfrom the HomeLinkfi button you wish to program whilekeeping the HomeLinkfi indicator light in view.3UNDERSTANDING THE FEATURES OF YOUR VEHICLE 267
参考になったと評価
30人が参考になったと評価しています。
その他の取扱説明書
2809 view
727 view
1920 view
912 view
339 view
もっと見る